pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Part 1 of 3|Page 3618 > < Part 1 of 3|Page 3616
Page 3
background image

Numbers below refer to circled numbers on the diagnostic chart.

5.

Pressure less than specifications falls into two areas:

^

Regulated pressure less than specifications; the amount of fuel to injectors is OK, but pressure is too low, The system will be lean running and
may set Code 44. Also, possible hard starting cold and overall poor performance.

^

Restricted flow causing pressure drop; Normally, a vehicle with a fuel pressure of less than 165 kPa (24 psi) at idle will not be driveable.
However, if the pressure drop occurs only while driving, the engine will normally surge then stop as pressure begins to drop rapidly.

6.

Do not allow fuel pressure to build above regulated pressure. When battery voltage is applied to the pump test terminal, pressure should be above
325 kPa (47 psi) as the valve in the return line is partially closed.

CAUTION:Do not allow pressure to exceed 414 (60 psi), as damage to the regulator may result.

7.

This test determines if the high fuel pressure is due to a restricted fuel return line or a pressure regulator problem.

Part 1 of 3|Page 3618 > < Part 1 of 3|Page 3616