Bonneville V6-3800 3.8L Supercharged (1992)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement
Fig. 48 Front Wheel Speed Sensor Replace
Front
Wheel speed sensor is non-adjustable. Left and right speed sensors are not interchangeable.
Proper installation of speed sensor cables is critical. Failure to route cables properly could cause system malfunction due to over-stressing or abrasion.
Refer to Fig. 48, for proper routing of cables.
1.
Open hood, then disconnect wheel speed sensor connector, Fig. 48.
2.
Cut strap retaining sensor lead, then raise and support vehicle.
3.
Remove sensor lead from brackets, sensor retaining bolt, then the sensor.
4.
Inspect sensor face for build up of metallic particles, dirt, grease, or other contaminants. Clean as needed.
5.
Inspect sensor face for damage. Replace sensor if damage causes improper operation.
6.
If sensor is removed or replaced, coat sensor body with anti-corrosion compound where the sensor contacts knuckle.
7.
Reverse procedure to install. Torque sensor retaining bolt to 7 ft. lbs.