Bonneville V6-3800 3.8L VIN L SFI (1995)
Caution:
TO PREVENT PERSONAL INJURY, WEAR HEARING AND EYE PROTECTION FOR THE NEXT STEP
Using compressed air and a blow gun, blow air down terminal E (see Figure 3) on the harness side of connector C2 until no fluid can be seen being
expelled from the wire at S129. This will take several minutes.
5.
Thoroughly dry splice S129 and the wires 2 inches in both directions.
6.
Thoroughly clean the wires 2 inches in both directions of splice 5129 with an alcohol wipe (available locally) and allow to completely dry.
7.
Cut a 2" x 2" piece of electrical moisture sealant. Apply the moisture sealant patch to the splice by folding it over the wires. Make sure that there is
at least a 1/8 inch gap between any parallel wires to ensure that the patch can seal between the wires (see Figure 4). Press the patch together with
your fingers or duck bill pliers, making sure that the wires are completely sealed.
