Bonneville V6-3800 3.8L VIN L SFI (1995)
Tighten:
Tighten the crankshaft rear oil seal housing bolts to 15 N.m (11 lb ft). Use J 45059 to tighten the bolts an additional 50 degrees.
8.
Recheck the step height on each side to ensure the crankshaft rear oil seal housing did not move. If the step height is beyond specification, reinstall
the crankshaft rear oil seal housing and measure the step again. Replace the crankshaft rear oil seal housing if the clearance is still beyond
specification.
9.
Continue with oil pan installation as outlined in the Service Information Manual.
Warranty Information:
