Bonneville V6-3800 3.8L VIN L SFI (1995)
1. Air mix valve actuator and mounting screws.
-
Tighten screws to 1.4 Nm (12 lb. in.).
2. Electrical connector.
3. Temperature valve link rod.
4. Adjust Temperature Valve Link Rod.
a. Pull valve link from retainer on programmer output crank (if not left disassembled).
b. Start car; set fan to HI and temperature to 33°C (90°F). If ambient temperature is above 33°C (90°F), disconnect in-vehicle temperature sensor.
c. Allow 45 seconds minimum for programmer motor to move output crank to its full hot position. Then move temperature valve to full hot
position; snap valve link into retainer on output crank.
5. I/P assembly.
-
Enable SIR system, Refer to Air Bags and Seat Belts. See: Restraint Systems/Air Bag Systems
Actuator (Heater A/C BI-Level Valve)
WARNING: The following procedures must be followed In the order listed to temporarily disable the Supplemental Inflatable Restraint
(SIR) system and prevent false diagnostic trouble codes from setting. Failure to follow this procedure could result In possible air bag
deployment, personal Injury, or otherwise unneeded SIR system repairs.
