Bonneville V6-3800 3.8L VIN L SFI (1995)
12.
Lower center trim plate.
13.
Install two center trim plate fasteners located below ashtray assembly.
14.
Install ashtray insert by pushing in.
15.
Install transmission lever control handle.
16.
Install console rear trim plate.
Correction for Condition # 2: (1993-95 Bonneville)
Important:
Bulb housing in this procedure is GRAY/WHITE in color and has an "X" molded into the housing (see item 4, Figure 1). Condition # 2 requires
replacement P/N 25537162.
1.
Remove transmission lever control handle. Refer to Section 8C in the Service Manual
2.
Remove console rear trim plate by pulling up.
3.
Remove ashtray insert by pulling out.
4.
Remove two center console trim plate fasteners located beneath ashtray insert.
5.
Lift up center console trim plate (see item 1, Figure 1).
6.
Put shift lever in the "P" Park position.
7.
Remove one 7 mm screw from PRNDL bulb housing (see item 4, Figure 1). Use 7 mm wrench.
The PRNDL lamp housing is located on the lower left front of the shifter assembly.
8.
Remove bulb socket from housing. Dispose of housing.
9.
Install bulb socket into new housing. P/N 25537162.
10.
Install bulb housing assembly to shifter assembly using one 7mm screw (see Item 2, Figure 1).
11.
Lower center trim plate.
12.
Install two center trim plate fasteners located below ashtray assembly.
13.
Install ashtray insert by pushing in.
14.
Install transmission lever control handle.
15.
Install console rear trim plate.
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty.
