Bonneville V6-3800 3.8L VIN L SFI (1995)
Symptom Table (Part 2 Of 3)
Symptom Table (Part 3 Of 3)
Circuit Operation
When either Front Door Handle is operated, terminal C1/K of the Remote Accessory Control (RAC) Module is grounded. This signals the RAC module
to turn on its output at C1/J, grounding the Interior Lamps Relay coil, and energizing the relay. With the relay energized, its contacts close to provide a
ground path for the Interior Courtesy Lamps. The interior lamps turn on. If any door is left open, the interior lamps remain on for approximately 10
minutes. If all doors are closed before the 10 minutes expire, the RAC Module senses that ground is removed from terminal C1/C. This initiates a
timing cycle that keeps the interior lamps on for an additional 25 seconds. If the Ignition Switch is turned to RUN before the 25 seconds expire, the
RAC Module senses battery voltage at terminal C1/B and turns off the interior lamps.
Also, when either Front Door Handle is operated, the RAC Module turns on its output at C1/E providing ground for the LH and RH Front Door LED
Key Cylinder Lamps (if equipped). This causes the lamps to light.
