Bonneville V6-3800 3.8L VIN L SFI (1995)
Wheel Bearing: Service and Repair
Rear
REAR HUB AND/OR BEARINGS
Fig. 2 Hub & Bearing Assembly
1. Raise and support rear of vehicle.
2. Remove wheel assembly and brake drum. Do not hammer on drum as damage to bearing may occur.
3. Disconnect ABS sensor wire.
4. Remove four hub and bearing assembly to axle attaching bolts. These four bolts also support brake assembly. When removing these bolts,
support brake assembly with a wire. Do not let brake line or ABS electrical wire support brake assembly.
5. Remove hub and bearing assembly from axle, Fig. 2.
6. Reverse procedure to install. Tighten attaching bolts to 70 Nm (52 ft. lbs.).
