Bonneville V8-4.6L VIN Y (2004)
Alarm Module: Service and Repair
Theft Deterrent Control Module
THEFT DETERRENT CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the knee bolster.
2. Remove the instrument cluster trim plate bezel.
3. Remove the radio.
4. Remove the PASS-Key III(R) module (3) from the instrument panel.
4.1.
Insert your right hand through the opening at the left side of the radio opening.
4.2.
Push the tab (1) towards the left side of the vehicle.
4.3.
Grasp the module through the knee bolster opening.
4.4.
Push the module (3) forward to remove.
5. Disconnect the electrical connector (2).
INSTALLATION PROCEDURE
1. Install the electrical connector (2).
2. Install the PASS-Key III(R) module into the instrument panel.
2.1.
Align the module (3) to the opening in the instrument panel.
2.2.
Pull the module rearward until the retainer tab (1) snaps in place.
3. Install the radio.
4. Install the instrument cluster trim plate bezel.
5. Install the knee bolster.
6. Perform the Programing Theft Deterrent System Components procedure. Refer to Programming Theft Deterrent System Components. See:
Testing and Inspection/Programming and Relearning
