Bonneville V8-4.6L VIN Y (2004)
Rear Door Weatherstrip: Service and Repair
Rear Side Door Upper Auxiliary Weatherstrip Replacement
Rear Side Door Upper Auxiliary Weatherstrip Replacement
Removal Procedure
1. Remove the door trim panel.
2. Remove the door module.
3. Remove the water deflector.
4. Remove the energy absorber pad.
5. Remove the window inner belt seal.
6. Remove the window outer belt seal.
7. Remove the door window.
8. Remove the rear door stationary window.
9. Remove the rear door upper auxiliary weatherstrip fasteners (1-7).
10. Carefully peel the auxiliary weatherstrip away from the door header.
Installation Procedure
1. Seat the top of the seal lip over the door header flange.
2. Align the front hole in the weatherstrip to the plastic nut in the door header.
3. Starting at the front, roll the weatherstrip over the flange on the door header while holding the weatherstrip lip to prevent it from tucking under
against the door.
4. Ensure the front fastener (1) hole is aligned with the plastic nut in the door header.
5. Install the auxiliary weatherstrip fasteners.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the auxiliary weatherstrip fasteners.
Tighten the fasteners, starting with the front fastener (1) to 2 N.m (18 lb in).
7. Install the door to door seal on to the forward flange of the door header starting at the top and working towards the bottom.
8. Install the rear door stationary window.
9. Install the door window.
10. Install the window outer belt seal.