Bonneville V8-4.6L VIN Y (2004)
Hood Shock / Support: Service and Repair
Hood Open Assist Rod Replacement
Hood Open Assist Rod Replacement
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the
rod because damage or bending will result.
1. Open and support the hood.
2. Using a small flat bladed screwdriver, release the clip securing the hood assist rod to the lower assist rod ball stud.
3. Using a small flat bladed tool, release the clip retaining the hood assist rod to the upper assist rod ball stud.
4. Remove the hood assist rod (4) from the vehicle.
Installation Procedure
1. Press the hood assist rod (4) onto the upper hood assist rod ball stud (1).
2. Press the hood assist rod (4) onto the lower hood assist rod ball stud (3).
3. Ensure that both clips are fully seated on the hood assist rod (4).
4. Close the hood.
