Bonneville V8-4.6L VIN Y (2004)
2. Slide the run channel up along the window, making sure the upper portion is under the door frame applique and the water shield is against the
rearward surface of the inner door panel above the latch.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower fastener (2).
Tighten the lower fastener to 9 N.m (80 lb in).
4. Lower the window to the full down position.
5. Pull out enough of the lower rear edge of the window seal to install the upper fastener in the run channel and door applique.
6. Install the fastener.
Tighten the fastener to 2 N.m (18 lb in).
Important: When reusing the window weatherstrip, the flange mounting area (1) must be pinched together to counteract the splaying
effect when removed. Use thumb and index finger to pinch the carrier (2) back together. Work from one end of the weatherstrip to the
other.
7. Reinstall the window weatherstrip into the door frame.
8. Install the window inner belt seal.
9. Install the water deflector.
10. Install the door trim panel.
