Bonneville V8-4.6L VIN Y (2004)
8. Install the 2 master cylinder brake pipes (1) to the BPMV (2) using the locations recorded during the removal procedure.
^
Tighten the 2 brake pipes to 15 Nm (11 ft. lbs.).
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON
position.
9. Install the EBCM electrical connector (1) to the EBCM (4).
10. Rotate the EBCM connector tab (2) down to the locked position.
11. Install the connector position assurance (2) to the EBCM electrical connector (1).
12. Install the air deflector.
13. Install the left front fascia extension.
14. Install the left front tire and wheel assembly.
15. Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling and Hydraulic Brake System Bleeding (Manual) or
