Bonneville V8-4.6L VIN Y (2004)
10. Remove the brake pedal assembly mounting nuts from the booster studs (2, 3).
11. Remove the brake pedal assembly.
Installation Procedure
1. Install the brake pedal assembly into position on the brake booster and cowl studs.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake pedal assembly to brake booster mounting nuts (2, 3).
^
Tighten the brake pedal assembly to booster stud mounting nuts to 23 Nm (17 ft. lbs.).
3. Install the brake pedal assembly to cowl stud mounting nuts (1).
^
Tighten the brake pedal assembly to cowl mounting nuts to 16 Nm (12 ft. lbs.).
4. Apply a small amount of lubricant, (GM P/N 12346293) or equivalent, to the clevis pin of the brake pedal (1).
5. Connect the vacuum brake booster pushrod (1) to the brake pedal clevis pin.
6. Install the foam spacer (2) to the brake pedal clevis pin.
7. Install the retainer clip (3) to the brake pedal clevis pin.
8. Install the TCC/cruise control release switch to the brake pedal assembly.
