Bonneville V8-4.6L VIN Y (2004)
10. Remove the surge tank inlet fitting.
11. Remove the rear lift bracket bolt.
12. Remove the rear lift bracket.
13. Remove the Exhaust Gas Recirculation (EGR) valve.
14. Disconnect the EGR inlet pipe nut (1) from the exhaust crossover.
Important: The EGR valve inlet pipe incorporates a crush seal connection at the water crossover. The EGR valve inlet pipe must be replaced if
disconnected from the water crossover.
15. Remove the EGR inlet pipe bolt (2) and flange (3) from the water crossover.
16. Remove the EGR inlet pipe and discard.
17. Disconnect the electrical connector from the manifold absolute pressure (MAP) sensor.
