Bonneville V8-4.6L VIN Y (2004)
3. Install the J28467-501 (1, 7) onto fender rails near the strut towers.
4. Install the cross car tube J 28467-3 (2) to the J 28467-501 (1, 7).
5. Install the radiator shelf tube J 28467-2A on top of the cross car tube J 28467-3 (2) over the J 42504.
6. Install the round tube of the front support assembly J 28467-4A (4) through the large hole in the radiator shelf tube J 28467-2A. The hole used in
the radiator shelf tube J 28467-2A (5) depends on the vehicle application.
7. Place the rubber padded foot of the front support assembly J 28467-4A on the upper tie bar.
8. Install the 7/16 inch x 2.0 inch quick release pin J 28467-9 through the hole in the front support assembly J 28467-4A in order to level the radiator
shelf tube J 28467-2A.
9. Install the lift hook J 28467-7A through the lift hook bracket J 28467-6A (5).
10. Install the assembled lift hook bracket J 28467-6A (6) over the strut tower tube J 28467-3 (2).
11. Install the lift hook J 28467-7A through the rear engine lift hook bracket. Ensure the hook does not damage the surrounding components.
12. Repeat steps 17 and 18.
13. Install the assembled lift hook bracket J 28467-6A (1) over the radiator shelf tube J 28467-2A (2).
14. Adjust the assembled lift hook bracket J 28467-6A (1) in order to align the hook with the J 42504.