Bonneville V8-4.6L VIN Y (2004)
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Important: Engine oil cooler quick connect fittings must be replaced whenever they are removed from the engine oil filter adapter.
1. Install the engine oil cooler quick connect fittings to the engine oil filter adapter.
^
Tighten the fittings to 18 Nm (113 ft. lbs.).
2. Push the engine oil cooler pipes fully into the new engine oil cooler quick connect fittings, until a "click" is heard.
3. Tug gently on the cooler pipes to ensure proper retention.
4. Slide the plastic cap over the quick connect joint.
5. Route the radiator side of the engine oil cooler pipes in front of the radiator.
6. Lower the vehicle.
7. Install the cooling fans.
