Bonneville V8-4.6L VIN Y (2004)
6. Loosen the center bolt of the J 45930 until the center hub protrudes approximately 13 mm (0.5 inch) beyond the outer plate. It is not necessary to
completely unthread the center bolt and separate the 2 pieces of the J 45930.
7. Install the J 45930 to the rear of the crankshaft.
8. Thread the 2 mounting bolts into the crankshaft flange.
9. Tighten the bolts until the J 45930 is firmly mounted on the crankshaft.
10. Install the crankshaft rear oil seal by tightening the center bolt until the J 45930 bottoms against the crankcase.
11. Loosen the center bolt to release pressure on the crankcase.
