Bonneville V8-4.6L VIN Y (2004)
7. Remove the right insulator panel.
8. Remove the Connector Position Assurance (CPA) (4) from the vehicle harness yellow connector (2) located below the Instrument Panel (I/P) (3).
9. Disconnect the I/P module yellow connector (1) from the vehicle harness yellow connector (2).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the I/P module yellow connector (1) to the vehicle harness yellow connector (2).
3. Install the CPA (4) to the vehicle harness yellow connector (2).
4. Install the right insulator panel.
5. Install the SIR fuse into the rear fuse center.
6. Install the rear fuse center cover.
7. Install the rear seat.
8. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
