Bonneville V8-4.6L VIN Y (2004)
below. Refer to the Off- Board procedure in Service Programming System (SPS) in Programming.
1. Install the PCM (1).
2. Install the PCM connectors.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the PCM connectors screws to 8 N.m (71 lb in).
3. Install the air cleaner cover (3) onto the air inlet housing.
4. Snap the assembly clamps into place.
5. Align the intake air duct/resonator assembly (3) into place.
6. Install the screw onto the intake air duct/resonator assembly.
Tighten the intake air duct clamp to 3 N.m (27 lb in).
7. Connect the battery negative cable.
8. Program the PCM. Refer to Service Programming System (SPS) in Programming. See: Testing and Inspection/Programming and Relearning
