Bonneville V8-4.6L VIN Y (2004)
Tighten fasteners to 9 N.m (80 lb in).
5. Connect the SDM wiring harness connector (3) to the SDM (2).
6. Install the push-on clip (1) securing the SDM wiring harness to the console stud.
7. Push down the flex lock button (3) and then move the sliding connector locking cover (4) to the close position.
8. Install the CPA (1) to the inflatable restraint SDM wiring harness connector (2).
9. Install the rear carpet into the vehicle.
10. Install the front split bench seat.
11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , SIR Disabling and Enabling Zone 8 and SIR Disabling and Enabling Zone
9.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
