Bonneville V8-4.6L VIN Y (2004)
Inflatable Restraint Sensing And Diagnostic Module: Service and Repair
Inflatable Restraint Sensing and Diagnostic Module (AM6)
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT (AM6)
REMOVAL PROCEDURE
CAUTION:
-
Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is
securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause
SIR deployment, personal injury, or unnecessary SIR system repairs.
-
If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM
and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and
result in personal injury.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 , SIR Disabling and Enabling Zone 8 and to SIR Disabling and Enabling
Zone 9.
2. Remove the front split bench seat.
3. Remove the rear carpet from vehicle.
4. Remove the connector position assurance (CPA) (1) from the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector
(2).
5. Push down the flex lock button (3) and then move the sliding connector locking cover (4) to the open position.
