Bonneville V8-4.6L VIN Y (2004)
6. Remove the push-on clip (1) securing the SDM wiring harness to the console stud.
7. Disconnect the SDM wiring harness connector (3) from the SDM (2).
8. Remove the SDM mounting fasteners (1).
9. Remove the SDM (2) from the console floor (3).
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SDM (2) horizontally to the console floor (3).
3. Point the arrow on the SDM toward the front of the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the SDM mounting fasteners (1).
Tighten
