Bonneville V8-4.6L VIN Y (2004)
7. Using J 43828 separate the lower ball joint from the steering knuckle.
8. Remove the front strut to steering knuckle retaining bolts (3) and nuts (1).
9. Remove the steering knuckle from the vehicle.
Installation Procedure
1. Install the steering knuckle to the lower ball joint.
Notice Refer to Fastener Notice in Service Precautions.
2. Install lower ball joint retaining nut.
^
Tighten the lower ball joint nut (2) to 10 Nm (89 inch lbs.) plus an additional 180 degrees.
Important: Do not exceed two slots during cotter pin alignment
