Bonneville V8-4.6L VIN Y (2004)
12. Remove the left insulator panel.
13. Remove the CPA (1) from the steering wheel module coil yellow connector (4) located near the steering column (2).
14. Disconnect the steering wheel module coil yellow connector (4) from the vehicle yellow harness connector (3).
15. Remove the CPA (3) from the LF/driver side impact module yellow connector (1) which is located under the driver seat.
16. Disconnect the vehicle harness yellow connector (2) from the LF side impact module yellow connector (1).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the vehicle harness yellow connector (2) to the LF side impact module yellow connector (1).
3. Install the CPA (3) to the LF side impact module yellow connector (1).
