Bonneville V8-4.6L VIN Y (2004)
6. Remove the stabilizer shaft and insulators.
Installation Procedure
1. Install the stabilizer shaft and insulators. Install the insulator into the clamp with slit forward.
2. Bend the stabilizer shaft bend link downward to close around the insulator. Ensure that the stabilizer shaft is centered and install the clamp bolt.
Notice Refer to Fastener Notice in Service Precautions.
3. Install the link assembly insulators, retainers and the support bolt and nut.
^
Tighten the link assembly nut and bolt to 15 Nm (11 ft. lbs.).
^
Tighten the clamp bolt to 33 Nm (24 ft. lbs.).
4. Lower the vehicle.