Bonneville V8-4.6L VIN Y (2004)
8. Remove the wheel bearing/hub retaining bolts.
Important: Replace the hub and bearing only as an assembly.
9. Using J 28733-B, separate the wheel bearing/hub from the drive axle.
10. Remove the wheel bearing/hub from the steering knuckle.
11. Remove the dust shield.
12. Clean the rust and the foreign material from the following components in order to allow proper seating of the bearing into the knuckle:
^
The knuckle mounting face
^
The bore
^
The chamber
Installation Procedure
1. Remove the protective plastic cover before installation. Do not handle the knuckle or hub assembly by the ABS sensor wire.
2. Install the wheel bearing/hub to the drive axle. Apply a thin layer of grease to the knuckle bore.
Notice Refer to Fastener Notice in Service Precautions.
3. Install the wheel bearing/hub retaining bolts.
^
Tighten the wheel bearing/hub bolts to 95 Nm (70 ft. lbs.).
4. Install the new drive axle nut, draw wheel bearing/hub onto the axle.
