Bonneville V8-4.6L VIN Y (2004)
12. Using the J 2619-O1, the J 29794, and the J 33008-A, disengage the wheel drive shaft (2) from the transaxle (1).
13. Remove the wheel drive shaft from the vehicle.
Installation Procedure
1. Install the wheel drive shaft (2) to the transaxle (1).
2. Verify that the wheel drive shaft is properly engaged to the transaxle by grasping the inner tripot housing and pulling outward. Do not pull on the
wheel drive shaft bar. The wheel drive shaft will remain firmly in place when properly engaged.
3. Install the wheel drive shaft to the hub and bearing (2).
4. Connect the ball joint to the steering knuckle.
5. Connect the wheel speed sensor electrical connector.
6. Install the stabilizer shaft link.