Fiero L4-151 2.5L (1985)
Torque Converter: All Technical Service Bulletins
A/T - Torque Converter End Play Measurement, New Tool
Number
85-7-21
Date
5/85
Subject:
NEW TORQUE CONVERTER END PLAY MEASUREMENT TOOL
ALL MODELS ALL YEARS
Figure 1 - J 35138 TORQUE CONVERTER END PLAY MEASUREMENT TOOL
A new, essential Torque Converter End Play Measurement tool, Kent-Moore number J 35138 (refer to Figure 1), has been developed and will be shipped
to GM dealers approximately May, 1985. This new universal tool replaces the previously released End Play Measurement tools, Kent-Moore numbers J
28538, J 25020-02, J 29060, J 21371 and J 29830.
Using J 35138, end play measurement on all torque converters is performed as follows:
1.
Screw upper and lower knurled knobs together.. Be sure collet end is not expanded (refer to Figure 1).
Figure 2 - INSTALLING J 35138 INTO CONVERTER
2.
Insert J 35138 into the torque converter hub (refer to Figure 2).
3.
Slide tapered plug into torque converter hub. Plug is for alignment of tool.
4.
Hold upper knurled knob and turn wing nut clockwise until hand tight to expand collet into converter turbine hub. Then loosen wing nut (counter
clockwise) 2 1/2 turns, or until tool is loose (will move up and down) while not removable from converter.
5.
Hold upper knurled knob and turn lower knurled knob clockwise until hand tight to clamp tool in the converter turbine hub.
