Fiero V6-173 2.8L (1986)
Fig. 3 Toe-in adjustment
TOE-IN ADJUSTMENT
1.
Loosen jam nuts on toe link rod, then rotate rods until toe-in is within specifications, Fig. 3.
2.
Torque jam nuts to 47 ft. lbs. Use care not to twist or damage rubber boots.
SERVICE MANUAL BULLETIN
INSTRUCTIONS:
1.
Make any necessary preparations for front wheel alignment.
2.
Mount J 36419 adjustment tools on the upper control arm shaft and hand tighten the thumb wheels onto the cross shaft (See Figure 5).
3.
Turn adjusting screws until swivel pads contact the frame (securely).
4.
Loosen the shaft bolts as required. See Figure 4.
A) Pivot bolt should be only slightly loosened.
B) Opposite bolt should be very loose.
5.
NOTICE: THIS TOOL WILL ALLOW FOR OUTWARD ADJUSTMENTS ONLY INWARD ADJUSTMENTS MUST BE MADE
MANUALLY- OR -THE UPPER ARM CAN BE MOVED TO A FULL INWARD POSITION AND THEN ADJUSTED OUTWARD AS
REQUIRED USING J 36419. TURN APPROPRIATE ADJUSTING SCREW CLOCKWISE TO MOVE UPPER ARM OUTWARD (SEE
FIGURE 2).
