Fiero V6-173 2.8L (1986)
Alignment: Service and Repair
Rear Wheel Alignment
CAMBER ADJUSTMENT
1.
Loosen both strut-to-knuckle attaching bolts sufficiently to allow movement between strut and knuckle.
2.
Move top of tire inboard or outboard until camber is within specifications, then torque both strut-to-knuckle bolts to 140 ft. lbs. If complete
torque cannot be applied to bolts due to inaccessibility, tighten bolts just enough to hold camber position, then remove wheel and wire
and apply final torque.
1988
1.
Loosen adjuster tube clamps.
2.
rotate adjuster tube to change toe-in angle.
3.
Torque clamps to 47 ft. lbs.
