Fiero V6-173 2.8L (1986)
FIGURE 3 - SHIFT SHAFT
2.
Shift the transaxle to first gear (fig. 2). Note: The 1st/2nd shift shaft should not be in the up position, "higher than the 3rd/4th and reverse shift
shafts". Visually check to be sure the interlock pin is in place in the 1st/2nd shift shaft (fig. 3). If the pin is missing, contact Pontiac Technical
Assistance for disposition of the transaxle.
FIGURE 4 - NEUTRAL POSITION
3.
Shift the transaxle to neutral (fig. 4). The 1st/2nd, 3rd/4th and reverse shift shafts should now be the same height. Also, the input shaft should turn
freely.