Fiero V6-173 2.8L (1986)
FIGURE 5 - BOLT "A" REMOVAL
NOTICE:
When performing the following steps, never remove more than one detent holder bolt at a time (fig. 5).
4.
Place a screwdriver in the breather hole and remove bolt A. (DO NOT REMOVE BOLT B AT THIS TIME). Discard the bolt (fig. 5). Note:
Screwdriver restricts detent holder assembly from sliding away from shafts and prevents loss of detent balls into case.
FIGURE 6 - DETENT HOLDER ASSEMBLY
5.
Place the new interlock plate on the detent holder assembly. Screw in a new 9 mm x 32 mm bolt 3 to 4 turns (fig. 6).
