Firebird V6-173 2.8L VIN L 2-bbl HP (1983)
2.
Governor gear is worn in the middle, 1. The governor dowel pin is located 1. Replace the transmission case. but on one side only (see Figur
2.
Governor sleeve stuck in case bore. 2. Replace governor assembly and transmission case.
3.
The output shaft toinput carrier 3. Disassemble the transmission, resnap ring is loose or has come off. place the output shaft to input
The output shaft has moved rear
carrier snap ring (part number
ward.
8642230).
Figure 4
Figure 5
3.
Governor gear is worn at the edge The governor dowel pin is located too Arbor press the dowel pin into the case of the gear on one
4.
Governor gear is worn slightly, 1. The incorrect governor gear was 1. Replace the governor gear (part the entire length of the gear (see
Figure 5).
a THM 350C gear as a replacement
gear.