Firebird V6-3.8L VIN K (1995)
Backup Lamp: Initial Inspection and Diagnostic Overview
Chart #1 Fuse(S) Blows When Replaced
Symptom Table
Troubleshooting Hints
Perform before beginning System Diagnosis
^
Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a
continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be
checked by monitoring for a voltage drop with the system operational (under load).
^
Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to
"Diagnostic
Aids/General Troubleshooting Procedures,"). See: Diagrams/Diagnostic Aids
^
Refer to
System Diagnosis. See: Flow of Diagnosis
