Firebird V6-3.8L VIN K (1995)
Install or Connect
1. Position new or repaired fuel pipe or pipes in body clips as noted during removal and install with attaching hardware.
2. Position new 0-ring on fuel feed pipe and connect to outlet side of in-line fuel filter.
Tighten
Fitting to 30 Nm (22 lb. ft.).
3. Fuel return and EVAP pipes to rear fuel pipes.
4. Chassis fuel pipes to engine compartment connecting fuel pipes.
5. Lower vehicle.
6. Tighten fuel filler cap.
7. Negative battery cable.
INSPECT
Turn ignition switch to "ON" position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position and check for fuel leaks.
