Firebird V8-305 5.0L VIN E (1992)
4.
Refer to Figure 8. Relocate solenoid to new location.
NOTE:
Check right or left orientation of bracket holes to mounting area. For best results, the solenoid forward hole is usually mounted on the inner panel 102
mm (4") left side and 112 mm (4.5") right side from the forward flange. Check clearances, cylindrical portion of solenoid must hang below the edge of
the inner panel without interference.
The left hand solenoid must be positioned low enough to prevent interference with the solenoid plunger.
5.
Mark new hole locations. Mount solenoid with new self drilling screws, P/N 12517487.
6.
Attach electrical cable to clamp and mount. If a bind condition is noted after mounting cable, remove cable from clamp and allow to move freely.
