pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Trim Pad Switch and Remote Handle Mount Panel|Page 6516 > < Trim Pad Switch and Remote Handle Mount Panel|Page 6514
Page 2
background image

Armrest

REMOVE OR DISCONNECT

1. Screws (3 and 4) retaining armrest (2) to the door trim panel, the armrest hanger plate, and the trim pad switch and remote handle mount panel (5).
2. Armrest (2) from the door trim panel and the trim pad switch and remote handle mount panel (5).

INSTALL OR CONNECT

1. Armrest (2) to the door trim panel and the trim pad switch and remote handle mount panel (5).
2. Screws (3 and 4) tighten to 5 Nm (44 lb. in.).

Inside Lock Rod Knob

Lock Rod Knob

REMOVE OR DISCONNECT

1. Inside lock rod knob (20).
2. Slide lock rod knob (20) forward.
3. Insert a small flat-bladed tool behind the end of the lock rod knob (20) and pry it away from the rod.         

INSTALL OR CONNECT

1. Inside lock rod knob (20).
2. Insert end of the lock rod knob (20) through the hole in the trim pad switch and remote handle mount panel (5).
3. Slide the lock rod knob (20) rearward until the end of the rod engages the depression in the end of the lock rod knob (20).

Water Deflector

Waterproof deflectors are used to seal the door inner panel and prevent entry of water into the body. The deflector is secured by an adhesive sealer
material along the front edges, rear edges and bottom, and by the application of waterproof sealing tape. Whenever work is performed where the water
deflector has been disturbed, the deflector must be properly sealed and taped to the inner panel to prevent water leaks. For service sealing, strip caulking

Trim Pad Switch and Remote Handle Mount Panel|Page 6516 > < Trim Pad Switch and Remote Handle Mount Panel|Page 6514