Firebird V8-305 5.0L VIN E (1992)
REMOVE OR DISCONNECT
Tool Required: J-24595-C Door Trim Pad and Garnish Clip Remover.
1. Remote handle mount panel.
2. Window regulator handle.
3. Door trim panel (1) using J-24595-C.
^
Push the door trim panel (1) outboard and upward to disengage it from the upper retaining clips.
INSPECT
^
Door trim panel retainers for damage. Make sure the retainers are installed securely into the door trim panel (1). Replace if necessary.
INSTALL OR CONNECT
1. New trim retainers into the door trim panel (1), if necessary.
^
Insert the retainer flange into the cutout attachment hole in the door trim panel (1).
^
Rotate the retainer until the flange is fully engaged.
2. Door trim panel (1).
^
Position the top of the door trim panel over the upper flange of the door inner panel.
^
Press down on the door trim panel (1) to engage the upper retaining clips.
^
Position the door trim panel (1) so that the trim retainers are aligned with the attaching holes in the panel.
^
Tap the door trim panel retainers into the holes with the palm of the hand or a clean rubber mallet.
3. Window regulator handle.
4. Remote handle mount panel.
Inner Panel Cam
Inner Panel Cam
REMOVE OR DISCONNECT
1. Water deflector.
2. Bolts (41) retaining inner panel cam (40) to the door inner panel.
3. Inner panel cam (40) from window regulator balance arm roller (39).
4. Inner panel cam (40) through access hole.
INSTALL OR CONNECT
1. Inner panel cam (40) to window regulator balance arm roller (39).
2. Inner panel cam (40) to inner door panel.
3. Bolts (41) retaining inner panel cam (40) to the door inner panel. Tighten bolts (41) to 11 Nm (97 lb. in.).
4. Water deflector.
Inside Lock Rod Knob
