Firebird V8-305 5.0L VIN E TBI (1989)
8.
Disconnect the fuel injector electrical connectors.
9.
Remove the fuel rail attaching bolts.
10.
Remove the fuel rail assembly.
11.
Remove the O-ring seal from the tip of each injector, and discard.
INSTALLATION:
1.
Lubricate new injector O-ring seals with clean engine oil, and install on the tip of each injector.
2.
Install the fuel rail assembly into the intake manifold.
3.
Install the fuel rail attaching bolts, and the fuel tube bracket bolt, and tighten to:
^
Fuel rail attaching bolts to 20.0 Nm (15.0 lb.ft).
^
Fuel tube bracket bolt to 34 Nm (25.0 lb.ft).
4.
Connect the injector electrical connectors.
^
Rotate the injectors as required to avoid stretching the wire harness.
5.
Connect the vacuum line to the pressure regulator.
6.
Lubricate new O-rings and install them on the fuel feed and return lines.
7.
Connect the fuel lines, and tighten to 27.0 Nm (20.0 lb.ft), using a back-up wrench to support the fuel rail tube fittings.
8.
Check for fuel leaks:
a.
Temporarily connect the negative battery cable.
b.
With the engine OFF and the ignition ON, check for fuel leaks.
c.
Disconnect the negative battery cable.
9.
Install the intake plenum and runners.
10.
Connect the negative battery cable.
