Firebird V8-305 5.0L VIN F FI (1987)
Figure 3
*
If replacement of only the thrust bearing (Figure 3) (677) 4T60 or (676) 3T40 is necessary, use Steps 1 through 3. After Steps 1 through 3 are
completed move pinion gears to provide clearance to replace thrust bearing, then complete Steps 6 through 7 of assembly procedure.
Figure 4
Assembly -
1.
After cleaning pinion gear, apply Transjel J36850 (assembly lubricant or petroleum jelly) to the inside of gear. (Do not use any grease or axle
grease.)
Figure 5
2.
Install square cut washer (809) onto pinion gear shaft (804). Insert the shaft and washer into gear so washer is flush with gear and shaft is 3/4
inside gear.