Firebird V8-350 5.7L VIN P SFI (1996)
Figure 2
Remove or Disconnect
1.
Raise and suitably support vehicle. Refer to Section 0A in the Service Manual.
2.
Rear tires and wheels. Refer to Section 3E in the Service Manual.
3.
Plastic push pin retainers (20) attaching the extension molding (9).
4.
Plastic rivets attaching the extension molding (9) using a 7/32 inch drill bit.
5.
Rear fascia extension molding (9).
Remove the extension molding (9) from the wheelwell flange, then lift up the molding to remove it from the retainers (8) and pull the extension
molding (9) straight off toward the rear of the vehicle.
Install or Connect
1.
Rear fascia extension molding (9).
When installing the rear bumper fascia extension molding (9), start at the left or right wheelwell flange, and using a rubber mallet, install the
molding onto the retainers (9).
2.
New plastic rivets attaching the extension molding (9).
3.
Plastic push pin retainers (20) attaching extension molding (9).
4.
Rear tires and wheels. Refer to Section 3E in the Service Manual.
5.
Lower vehicle.
Rocker Panel Extension
