Firebird V8-350 5.7L VIN P SFI (1996)
Neutral Safety Switch: Service and Repair
Fig. 8 Neutral Safety Switch Replacement
REMOVAL
1. Disconnect battery ground cable.
2. Remove floor console, then disconnect electrical connectors from switch.
3. Place shift lever in Neutral position of detent plate, then remove switch attaching screws and switch, Fig. 8.
INSTALLATION
1. Ensure the shift lever is in Neutral, then position switch on shift lever making sure pin on shaft is in slot of switch.
2. If reinstalling existing switch, rotate switch to align service adjustment hole with carrier tang hole. Insert a 3/32 inch gauge pin and rotate switch
until pin drops in to a depth of 19/32 inch. Torque switch attaching nut to 18 inch lbs., then remove gauge pin.
3. If installing a new switch, torque attaching nuts to 18 inch lbs., then move shift lever out of Neutral to shear pin which is part of new switch.
4. Reconnect electrical connectors to switch, then apply parking brake and start engine. Check back-up lights and seat belt warning system for proper
operation and ensure engine will start only in Park or Neutral.
5. Turn ignition off and install floor console.
