pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Propeller Shaft - Vibration at Highway Speed|Page 6281 > < Propeller Shaft - Vibration at Highway Speed
Page 1
background image

Drive/Propeller Shaft: All Technical Service Bulletins
Propeller Shaft - Vibration at Highway Speed

File In Section: 4 - Drive Axle 

Bulletin No.: 67-41-01

Date: March, 1996

Subject: 
Vibration at Highway Speed (Replace Propeller Shaft)

Models: 
1993-96 Chevrolet Camaro
1993-96 Pontiac Firebird
with 5.7L V8 Engine (VIN P - RPO LT1)

Condition

Some owners may experience a vehicle vibration at highway speeds. When measured at the driver's seat track, this vibration will be a 1st order driveline
frequency. The same vibration can be confirmed at the axle pinion nose and at the rear extension housing of the transmission.

Important:

When measuring vibration frequency on a hoist, the rear of the vehicle must be supported by the axle tubes in order to maintain the proper vehicle
trim height. This will prevent vibration due to excessive driveline angle. Also, any vibration due to excessive driveline angle will appear as 2nd order
driveline frequency vibration.

Cause

First order driveline vibration may be caused by beaming between the engine and transmission.

Correction

A previously released propeller shaft is available to address the highway speed vibration condition. This reduced mass propeller shaft is constructed of
aluminum less a pinion damper.

Verify condition per above note that the vibration is 1st order driveline disturbance; preferably using an Electronic Vibration Analyzer (EVA).

Other conditions such as excessive driveline angle difference may produce 2nd order driveline vibration concerns. The proper procedures to measure and
correct for excessive driveline angle condition are not shown in the current Service Manual. Consult a 1992 Service Manual for the proper procedure.
The front and rear propeller shaft angle must be less than one (1°) degree of each other.

Important

Due to the removed damper, the alternate propeller shaft may unmask existing rear axle noise. A lighter propeller shaft will reduce vibration but will
possibly unmask axle noise, while a heavier propeller shaft will mask axle noise but may cause vibration. This inherent condition is always the
trade-off. It is suggested that the vehicle be test driven to evaluate axle noise before and after parts are installed.

Install alternate propeller shaft,
Part Number 10085375.

Warranty Information

For vehicles repaired under warranty, use:

Labor Operation

Labor Time

F1280

Use published labor operation time.

Propeller Shaft - Vibration at Highway Speed|Page 6281 > < Propeller Shaft - Vibration at Highway Speed