Firebird V8-350 5.7L VIN P SFI (1996)
^
Push rear of trim assembly (89) into door assembly (152) to engage tab.
2. Tighten bolts/screws (90) to 4.5 Nm (40 lb. in.).
3. Outside rearview mirror bezel assembly.
4. Front side door window regulator handle assembly and front side door window regulator handle spacer.
5. Front side door inside handle bezel.
6. Accessory switch panel assembly or accessory switch opening cover assembly, as equipped.
Front Side Door Locking Rod Knob
Installing Front Side Door Locking Rod Knob (Typical)
REMOVE OR DISCONNECT
1. Knob (32).
^
Slide knob (32) forward.
^
Insert a small flat-bladed tool behind end of knob (32) and pry it away from locking rod (49).
INSTALL OR CONNECT
1. Knob (32).
^
Position knob (32) over locking rod (49) and insert end of knob (32) through hole in handle bezel.
^
Slide knob (32) rearward over locking rod (49) until end of locking rod (49) fits into depression in lock knob (32).
^
Snap knob (32) over locking rod (49).
Front Side Door Water Deflector
NOTE: Whenever work is performed where the deflector (86) is disturbed, the deflector (86) must be properly sealed and taped to the door inner
panel to prevent waterleaks. For service sealing, strip caulking is recommended if additional sealing material is required.
When access to the door inner panel is required to perform service operations, the deflector (86) may be completely or partially detached from the
door inner panel. If the existing deflector (86) is damaged so that it will not properly seal the door assembly, replace the deflector (86).
If only partial removal of the deflector (86) is required, perform only the steps that are necessary to expose the required area of the door inner panel.
