Firebird V8-5.7L VIN G (2001)
Antenna Mast: Service and Repair
Power Antenna Mast Replacement
REMOVAL PROCEDURE
1. Turn the ignition switch to the ON position.
2. Turn the radio ON.
IMPORTANT: Note the orientation of the serrated side of the plastic cable in order to install the cable correctly.
3. Remove the antenna mast (3) and the contact spring (2).
4. Use contact cleaner in order to clean the contact spring (2).
INSTALLATION PROCEDURE
1. Insert the plastic cable into the housing (1). You will feel resistance after inserting about 30 cm (12 in) of the cable. Stop inserting the cable when
you feel resistance.
2. Turn the radio OFF.
Ensure that the plastic cable retracts into the housing (1) and catches onto the gear mechanism of the drum housing.
If the cable does not retract into the housing, rotate the cable until the cable rotates into the housing with the motor operating.
