pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8925 > < Initial Inspection and Diagnostic Overview|Page 8923
Page 2
background image

Current DTCs (21 to 25) are displayed in the diagnostic mode as long as the BCM detects the fault. Once the fault is corrected, the current DTCs are
cleared by the BCM.

To clear history DTCs (31 to 35) press and hold the door unlock switch for four seconds while the BCM is in the diagnostic mode. The BCM will sound
three audible warning tones to confirm that the DTCs are cleared.

To clear BCM history DTCs (31 to 35) on vehicles without power door locks, back probe the position for the door unlock signal Input with a fused
jumper to ground for four seconds. The BCM will sound three audible warning tones to confirm that the history DTCs have been cleared.

Leaving Diagnostic Mode

Perform the following to leave diagnostic mode:

1. Turn the ignition switch to OFF
2. Reinstall the Radio fuse in the IP fuse panel
3. Turn the ignition to RUN.

Initial Inspection and Diagnostic Overview|Page 8925 > < Initial Inspection and Diagnostic Overview|Page 8923