Firebird V8-5.7L VIN G (2001)
1. Lubricate the following components with silicone grease:
-
New bolt boots
-
New bushings
2. Install the following components into the caliper bracket (1):
-
The bolt boots (2)
-
The bushings
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the caliper bracket with the bracket bolts.
-
Tighten the caliper bolts to 100 Nm (74 ft. lbs.).
4. Install the inner and outer brake pads. Refer to Brake Pads Replacement- Front.
Rear
Brake Caliper Bracket Replacement- Rear
Removal Procedure
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
1. Remove the inner and outer brake pads. Refer to Brake Pads Replacement- Rear.
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
2. Remove the caliper bracket bolts (2).
3. Remove the caliper bracket (1).
Installation Procedure
