Firebird V8-5.7L VIN G (2001)
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Clean all dirt and foreign material from the brake hose (3) and the brake pipe fittings.
3. Remove the rear brake front pipe (2) from the brake hose (3).
-
Use a backup wrench on the brake hose fitting.
-
Do not bend the brake hose bracket (6) or the brake front pipe (2).
4. Remove the brake hose retainer (7) from the brake hose bracket (6) and the brake hose (3).
5. Remove the rear brake hose (3).
6. Remove the left rear pipe (1) and the right rear pipe (5) from the hose (3). Do not bend the left rear pipe (1) or the right rear pipe (5).
7. Note the position of the brake hose (3) for proper location during installation.
8. Remove the rear brake hose fitting bolt (8) and the brake hose (3) from the rear axle (4).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
