Firebird V8-5.7L VIN G (2001)
7. Connect the rear fitting of the front cable conduit to the floor pan bracket (1).
-
Pull the equalizer (3) back until the equalizer stops.
-
Connect the rear cables (2) to the equalizer (3).
8. Lower the vehicle.
9. Cycle the park brake lever (1) three times.
10. Install the front floor console. Refer to Park Brake Cable Replacement- Front.
Rear
Park Brake Cable Replacement- Rear
-
Tools Required
-
J 37043 Parking Brake Cable Release Tool
Removal Procedure
1. Fully disengage the park brake lever. Ensure that the handle is down and that the brake indicator lamp is not lit.
Important: If the park brake lever is partially engaged, you will not be able to pull the equalizer rearward later in this procedure.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Pull down on the front cable strand until the strand stops and stays extended.
4. Cut off the tie strap.